Home About us Products Models News Honor Network Contact us Substation
location:Home > conveyor beltingNews > Causes and maintenance measures that cause damage to self aligning ball bearing

Products
More models
Deep Groove Ball Bearing
KA Nylon Retainer Bearing
Deep Groove Ball Bearing
Black Chamfer lmported Process Bearing
35 Class Spherical Roller Bearing
36 Class Spherical Roller Bearing
Lightweight Spherical Roller Bearing
Self-Aligning Ball Bearing
One Way Backstop Bearing
Causes and maintenance measures that cause damage to self aligning ball bearing
Clicks:4999 Date:12-23
Before checking, clean the surface of the machine and remove the parts around self aligning ball bearing. The seal is very fragile parts, therefore need to be carefully removed, not excessive force, and then carefully check the oil seal and its surrounding parts, if have shown adverse symptoms, be sure to replace the bad oil seals will result in bearing damage and strict equipment downtime.
Cover the exposed bearing:
When checking self aligning ball bearing, do not let the bearings be exposed to the environment of pollutants or moisture. If the work is interrupted, the oil paper plastic film or similar material should be used to cover the machine.
If it is possible to carry out the inspection without dismantling, it is necessary to clean the unconcealment bearing. It should be cleaned with oil brushes coated with brushes, and then dried with a piece of uncoated cloth or dried with compressed air.
Check lubricants:
Touch a touch of lubricant between the two fingers. If there is a contaminant, it can be felt, or a thin layer of lubricant on the back of the hand, and then the light is sealed.
Replacement of lubricants:
Oil lubricated bearings after removing the old oil, if possible, then fill the fresh oil and allow the machine to rotate at low speed for a few minutes. As far as possible, the oil can be collected to collect residual pollutants, and then the oil is removed, and the oil is best filtered first before use.
The use of grease lubrication self aligning ball bearing in the replacement of grease when Joe remover should avoid contact with cotton to any part of the bearing, because the residues of these fibers may wedge rolling pieces and caused damage, especially the application of small bearings should pay more attention to this problem.
Previous article: Common sense of maintenance of self aligning ball bearing exception      Next article: Self aligning ball bearing maintenance and maintenance important link
Recommended reading
Aligning bearings and deep groove ball bearings What is the difference 2017.3.15
Analysis of bearing friction characteristics 2017.3.2
Three types of bearing operating environment 2017.3.2
Recommended products
bearing 6310 C4 for idler
bearing 6310 C4 for idler
bearing 6309 C4 for idler
bearing 6309 C4 for idler
bearing 6308 C4 for idler
bearing 6308 C4 for idler
bearing 6307 C4 for idler
bearing 6307 C4 for idler
 
Corporate Information
Home
Abouts Us
Products
News
Honors
Substation
 
Contacts
+86 635 5638235
Fax:+86 635 5638808
Address:Xu Village Industrial Garden, Gan Town, Guan County, Shandong
 
Follow us
 
Copyright © 2017 Shandong Xinkaite Bearing Co.,Ltd.